How to extinguish the fire after the insulation paper is on fire


Release time:

2023-05-07

Disconnect the host power supply of the fire insulation paper. If the insulation material accidentally fire, should immediately disconnect the host power. Then, according to the relative path and characteristics of the insulating layer material, carefully and carefully, find the common fault point of the insulating layer material. At the same time, personnel should be quickly arranged to put out the fire.

If the insulation material accidentally catches fire, the following methods should be used for fire fighting with insulation paper:

1. Disconnect the host power supply of the fire insulation paper. If the insulation material accidentally fire, should immediately disconnect the host power. Then, according to the relative path and characteristics of the insulating layer material, carefully and carefully, find the common fault point of the insulating layer material. At the same time, personnel should be quickly arranged to put out the fire.

2. In case of fire in the insulation material ditch, disconnect the host power supply of the insulation material that is not uncommon. When the insulation material in the insulation material groove accidentally catches fire, if the insulation material laid in parallel with the insulation material groove has obvious probability of accidental fire, the host power supply of these insulation materials should be disconnected.

3. Close the insulation material ditch fire door or block both sides of the insulation material ditch. When the insulation material in the insulation material ditch accidentally catches fire, in order to avoid air circulation and facilitate rapid fire fighting, the fire door of the insulation material ditch should be closed or blocked on both sides, and the suffocation method should be used to put out the fire.

4. Strengthen safety protection during fire fighting. Because the insulation paper will form a large amount of smoke and toxic gases when it accidentally catches fire, firefighters need to wear a gas mask when extinguishing the insulation material fire accident. In order to avoid physical electrocution during combat, workers should also wear rubber gloves and insulated boots.

5. Fire extinguishing equipment used to extinguish fire accidents of insulating material. Fire extinguishers such as dry powder fire extinguishers, "1211" fire extinguishers and carbon dioxide fire extinguishers shall be used to extinguish insulation material fires. It can also be covered with dry sand or yellow soil. If water is used to put out the fire, zuihao uses a spray gun. If the fire is very fierce and cannot be put out by other methods, water can be poured into the insulation material trench after the power supply of the main engine is disconnected, and common faults can be sealed with water to put out the fire.

6. When fighting insulation paper fire accidents, do not directly touch the insulation material armor or move the insulation material by hand.